Срывать – Научитесь планке

Введение

Planks can be very versatile – overcome ledges, scale walls, even cross large gaps – and I will endow you with some knowledge, so that you may conquer many obstacles.

I recommend you get the automatic dev map from the workshop and set the height bias up to about 1 10th of the slider, so you can practice using planks. И с этим, lets start with the very basics.

If you already know how to place a plank, you can skip the next section.

Самые основы

To use a plank, hold left click on a surface within grabbing distance (the crosshair will get a ring). While still holding left click, drag the plank to another surface within grabbing distance (to connect the two), or to open air (the plank will only be attached on one end). To test you can do this, let’s make a small ramp!

Find a small ledge, preferably one you cannot jump over on your own, but not so high you cannot reach the top of it. Start by attaching the plank to the top of the ledge. Затем, drag the plank down to the ground a bit away. Если все сделано правильно, you will have made a ramp that you can walk up to the top of the ledge!

Now we can move onto some contraptions which take more skill.

Bigger and Better pt1

Now that you know the basics, we can move on to larger and more complex creations, which will help us reach for the skies! Using logic and common sense, we can build up to the largest (and riskiest) строит.

Так, we can build up a small ledge, but what about larger ones? Ones you can’t reach from the ground? Хорошо, you can build up a staircase of ledges easily, вот так:

But there is no second ledge here – so what to do?

Хорошо, you can stand planks upright!

Using a vertical plank, you can create a ‘ledge’, and build up the larger ledge!

Now that we have this key concept, let’s move on to the second one!

Bigger and Better pt2

These ramps are all well and good, but what if you want just.. платформа? Something standalone, that you can use to generally just gain height? В этом случае, we need to start understanding structural integrity, and to learn not to rely on the joint stiffness; the rusty, fatigued nails you use to ‘secure’ your planks to other objects? Конечно, they almost never let go (just ask that poor van), but they so easily bend, any plank on a slant is bound to fall without something more. Just try – putting a plank on an angle is basically impossible without something to stop it falling.

Так, getting back on track, how do we get a platform?

We could make some sort of platform with two pillars (вертикальный) and a beam (horizontal), and put a small ramp to get up, но…

It will fall over easily, making it not viable for many uses. Однако…

A simple triangle can make all the difference! If you want to know why this works, find a different guide (not here, on the internet in general) on triangles and their stability. На данный момент, just know triangles are very stable. If you want a wider platform, all that is needed is to repeat the structure around.

Moving Across pt1

Let’s take a break from moving up. How do we get across walls and chasms without using the ground? Хорошо, let’s find out.

Here we have a wall and a hole that will be inconvenient to get out of. Первый, let’s see what not to do.

Этот

техническиработает, but it is thin and pretty unstable, due to it being half inside of the wall. I definitely do not recommend it, unless you are running very low on planks.

This no longer clips through the wall, but remember when i told you about the weak nails?

Через некоторое время, or objects falling on it, the planks will droop and the path become non passable.

Так, after all this, what is the correct* way to cross?

*subjectively

Здесь, I have made little platforms on the wall to put a walkway on. Notice how the platform forms a triangle with the wall, meaning it is stable and will not droop. С помощью этого метода, you can make an infinitely long, long lasting walkway that can even hold a load.

Moving Across pt2

Хорошо, вот мы и здесь. A destination, a gap, and everything to lose. How do we get across without falling?

Ответ… a lot of planks and a lot of patience.

Первый, we need a scaffold. If you just need to get across this can also be the finished product but I plan for the bridge to hold a load. Make a pillar, bring off a plank towards the ground (but DO NOT attach it to the ground!), then connect it back to the base of the pillar:

Then push it off. It should pivot into place!

This is one of the benefits of weak nails; you can push parts into place!

Однако, this is the place where I get to the point that I can no longer fully explain how to do this. But you will have to get some scaffolding below. As a result of me not being able to continue, I will provide some images of stages in construction.

Ой, кстати, you can time a plank falling so that you attach it in a way you could not normally. I use it in the next image.

Тест

You have done well if you made it this far. Однако, a good builder can use their knowledge to adapt to any given situation. So here is your test.

Your challenge is to scale these two walls, and get up to the top. It doesn’t have to be quite as tall as this, just tall enough to prove your creation. The creation must span (and rely on) both walls, not just one.

If you want to see my solution, scroll down. Если не, or you want to try the test and prove your worth,

не смотри дальше.Well here we are. Are you ready to see the answer?

the answer.
I used many of the tricks I explained earlier, such as the pivot i used in the scaffold for the bridge.