Marble World Basic Guide, Porady, i sztuczki

• Tytuł: Marble World
• Data wydania:
• Wywoływacz:
• Wydawca:

Wyświetl wszystkie przewodniki

Information about Marble World is still incomplete. Pomóż nam wypełnić szczegóły gry za pomocą tego formularz kontaktowy.

This guide will show you the basic Marble World controls and how to make a marble run, race, or prefab.

Marble World Controls

Marble World is a sandbox game for making marble runs or races, “but how do I do that?”, możesz zapytać. Here are the basic controls for Marble World:

• W – Move camera forward
• S – Move camera backward
• A- Move camera to the left
• D – Move camera to the right
• Left-Mouse click – Place down object of choice
• Right-Mouse click – Rotate camera around or look around, you can use this while moving the camera in the desired direction
• F – Spawn marbles, this only works if there is a marble spawner on the map
• [] – Open and/or close the marble spawner gate
• 0 (Zero) – Deletes all marbles on the map

Making a Marble Run

Dobrze, my friend, you’ve asked the right person! Here are some steps to making a marble run:

• Pierwszy, get a marble spawner by going into the “Marble Spawners” tab at the bottom left.
• Następny, place down your marble spawner with a left click of your mouse. You may want to place it at a downward sloped angle by going to the rotate tool, make sure that the checkered design is the lowest part of the slope!
• Teraz, we need some tracks, don’t we Mr. Stooge? Tak, I think we need some tracks. Go to the tracks tab at the bottom left-hand corner of your screen and get some straight tracks.
• Now that you have some straight tracks, you want to place them. Move the ghost image piece close to the marble spawner. See how the piece snapped right to the spawner? That’s good because we don’t want to manually align it perfectly, we want to let the game perfectly do it.
• Now let’s get a turn piece. Go to the tracks tab and switch to the “Curved” sub-tab, you can choose between 90 stopnie, 45 stopnie, Lub 180 degree turns. Make sure you’ve turned off an important setting, auto-rotate after the snap. To turn that off, just go to the settings at the top of your screen. Następnie, look for that setting and turn it off.
• Let’s snap our curve to the straight decline. Just like earlier, snap the curved piece to the decline. See how it isn’t at the same angle as the decline? It’s not at an angle, and is perfectly straight, like on the floor. This is how you should do turns after a ramp.
• Wreszcie, if you’d like to make a loop, simply just make a u-turn and connect the tracks together. You should use boost pads to have the marbles go up a slope, or just use an elevator. For boosters, idź do “Dekoracje” patka, then go to the “Physics” sub-tab, and you should see the boost pad, the boost pad has rainbow arrows. For the elevator, idź do “Upwards” patka. Następnie, you should see the elevator. Now that we have the up ramp, let’s connect the tracks by making the same turn as before. If there is a small jump or gap, don’t change it, but if you’d like, you can make it a solid track. If you like sweet jumps and tricks, you should keep the jump.